firmware-download-limit
The default concurrent connections for AP firmware download is 300 and the default bandwidth per AP firmware download connection is 1k bytes.
Global configuration mode
This command allow users to limit concurrent connections and bandwidth for AP firmware download. The default concurrent connections for AP firmware download is 300 and the default bandwidth per AP firmware download connection is 0k bytes. Users can change the concurrent connections to the number between 1 and 65535 and bandwidth to the number between 0k and 2147483647k. However, users must be careful to update these parameters because it impacts the controller (SmartZone) network resources.
The no form of this command is set as no limit on AP Firmware Download. That means it will set the connection to 65535 and bandwidth to 0k. The 65535 is the maximum value of concurrent connections. The bandwidth 0k means there is no limitation for AP firmware download rate.
The following example enables certificate checking for APs.
device# config device(config)# firmware-download-limit The limited number of firmware download connection is 300 and the download speed per connection in not limited. Please input connections in integer(1 ~ 65535) [suggestion: 300]: 200 Please input download speed limit in KB [suggestion: 256k]: 500 Successful operation % This configuration will take effect in a few minutes.
| Release version | Command history |
|---|---|
| 5.2.2 | This command was introduced. |