admin-radius

Configures the RADIUS server and enters Admin Radius configuration mode.
Syntax
admin-radiusname
no admin-radius[name]

After the admin-radius command is entered to enable the Admin Radius configuration mode, the following configuration syntax is available:

[ipip-address|namename|portport-number|shared-secret|testusernamepassword[chap|pap]|type{radius|tacacs}]
Command Default

The RADIUS server is not configured.

Parameters
name
Specifies the RADIUS server name.
ip-addressip-address
Sets the IP address for the primary RADIUS server.
namename
Sets the RADIUS server name.
portnumber
Sets the port number for the primary RADIUS server.
shared-secret
Sets the shared secret for the primary RADIUS server. Valid values range from 1 through 255 characters.
test
Tests the RADIUS server based on the user credentials and protocol settings.
username
Specifies the user name.
password
Specifies the password.
chap
Specifies the CHAP protocol.
pap
Specifies the PAP protocol.
type
Sets the authentication type.
radius
Specifies RADIUS authentication.
tacacs
Specifies TACACS authentication.
Modes

Global configuration mode

Usage Guidelines

The no form of the command removes RADIUS server configurations. If no RADIUS server is specified, all RADIUS server configurations are removed.

This command is supported on all SmartZone platforms except SmartZone Data Plane controller.

Examples

The following example enters Admin Radius configuration mode and configures the RADIUS server. 

device# config
device(config)# admin-radius aaa-auth
device(config-admin-radius)# ip 10.1.1.1
device(config-admin-radius)# port 1813
device(config-admin-radius)# shared-secret
Password: **
Retype: ***

The following example removes all RADIUS server configurations. 

device# config
device(config)# no admin-radius
Do you want to continue to delete (or input 'no' to cancel)? [yes/no] yes
Parent topic: Commands A through C