interface
Setup interface configuration.
Syntax
The SZ300/vSZ-H displays the following
syntax for interface command:
interface{cluster
|
control
|
management
|
user-defined
<name>}The SZ100/vSZ-E displays the following syntax for
interface
command:
interface{
ap-tunnel-data
|
mgmt-and-ap-control
|
user-defined
<name>}no
interface
{user-defined
|
<name>}Command Default
No interface configuration is setup.
Parameters
Modes
Global configuration mode
Usage Guidelines
The no form of the command
removes user defined interfaces.
This command is supported on all SmartZone platforms except SmartZone Data Plane controller.
Examples
The below example displays setting
interface configuration for SZ100.
device# config device(config)# interface ap-tunnel-data AP Tunnel Data mgmt-and-ap-control Management & AP Control user-defined User defined interface device(config)# interface mgmt-and-ap-control device(config-if)# data-plane Update Data Plane configuration do Do command end End the current configuration session and return to privileged EXEC mode exit Exit from the EXEC help Display this help message ip Update IP configuration no Disable and delete commands
Examples
The below example displays setting interface configuration for
SZ300.
device(config)# interface cluster Cluster interface control Control interface management Management interface user-defined User defined interface device(config)# interface cluster device(config-if)# do Do command end End the current configuration session and return to privileged EXEC mode exit Exit from the EXEC help Display this help message ip Update IP configuration