show alarm

Displays outstanding access point (AP) alarms.
Syntax
show alarm
Modes

Privileged EXEC mode

Usage Guidelines

This command is supported on all SmartZone platforms except SmartZone Data Plane controller.

Examples

The following example shows partial output from the show alarm command. 

device# show alarm

No. Datetime                 Code  Alarm Type        Severity       Status         Ack On Cleared By  
--- ------------------------ ----- ----------------- -------------- -------------- ------ ----------- 
  Cleared On               Comments       Activity
  ------------------------ -------------- ---------------------------------------
1   2020-03-20 04:30:32 GMT  907   ipmiThempP         Major         Cleared               System  
  2020-03-20 04:30:32 GMT  Auto Cleared   Processor [2] temperature [Too High] on control plane  
                                          [24:79:2A:00:0B:00].                                    
2   2020-03-20 04:31:00 GMT  303   AP disconnected    Major         Outstanding
                                          AP [RuckusAP@6C:AA:B3:3D:65:30] disconnected
3   2020-03-20 04:31:00 GMT  303   AP disconnected    Major         Outstanding             
                                          AP [RuckusAP@94:BF:C4:14:F8:80] disconnected
4   2020-03-20 04:31:00 GMT  303   AP disconnected    Major         Outstanding                
                                          AP [RuckusAP@EC:8C:A2:1F:92:20] disconnected
5   2020-03-20 06:17:48 GMT  811   Cluster node       Major         Outstanding            
                                   rebooted                           
                                          Node [KKK-SZ300] in cluster [SZ300] rebooted
.
.
.
Parent topic: Show Commands