Enabling and disabling support for 100BaseFX

Some RUCKUS devices support 100BaseFX fiber transceivers. After you physically install a 100BaseFX transceiver, you must enter a CLI command to enable it. For information about supported SFP and SFP+ transceivers on ICX devices, refer to the RUCKUS Optics Family Datasheet on the RUCKUS website.

Note: 100BaseFX is not supported on ICX 7850 and ICX 8100 devices.

In this section:

  1. Enabling and disabling 100BaseFX on Chassis-based and stackable devices
Parent topic: Basic port parameter configuration