Configuring LED Off Delay for an AP

To enable or disable LED Off Delay, perform the following steps:
Note: The LED Off Delay feature is only supported on the T670 APs.
  1. Log in to the Command Line Interface (CLI) of the AP.
  2. To enable LED Off Delay, enter the set led-off-delay enable command. 
    rkscli: set led-off-delay          
Usage: set led-off-delay {enable|disable}
                --only support T670 now
rkscli: set led-off-delay enable
set led-off-delay to enable
warning:1. The LED will automatically turn off after 10 minutes. Following an AP reboot, the LED will remain illuminated for 10 minutes before turning off.
        2. LED status settings configured from SZ or the cloud will not be applied.
OK
  3. To disable LED Off Delay, enter the set led-off-delay disable command. When disabled, the LED is restored to the LED settings configured by the controller.
    rkscli: set led-off-delay disable
set led-off-delay to disable
OK
OK
  4. To view the LED Off Delay status, enter the command get led-off-delay.
    rkscli: get led-off-delay
led-off-delay: disable
OK
Parent topic: AP Model Specific Configuration