lan rate-uplink

To set rate limiting on a port, use the following command:

lan NUMBER rate-uplink NUMBER

Note: The rate-uplink command is supported only for H550/H350 or H320/H510 in Gateway model.

Syntax Description

lan
Configure a specific port
NUMBER
Configure this port
rate-uplink
Set the uplink rate limiting
NUMBER
Enter the rate limiting to {NUMBER} Mbps, valid range is from 0 to 1000.

Defaults

None.

Example

ruckus(config-ap-model)# lan 1 rate-uplink 200
ruckus(config-ap-model)# show
PORTS:
    LAN ID:
          1:
            Rate Uplink= 200
ruckus(config-ap-model)#