adj-threshold

To configure the adjacent threshold for load balancing, use the following command:

adj-threshold [ wifi0 | wifi1 ] NUMBER

Syntax Description

adj-threshold
Configure the adjacent threshold for load balancing
wifi0, wifi1
Configure this interface
NUMBER
Set the adjacent threshold value (1~100)

Defaults

Wifi0: 50

Wifi1: 43

Example

ruckus(config-load-balancing)# enable wifi0
The command was executed successfully. To save the changes, type 'end' or 'exit'.
ruckus(config-load-balancing)# adj-threshold wifi0 25
The command was executed successfully. To save the changes, type 'end' or 'exit'.
ruckus(config-load-balancing)# show
Load Balancing:
  Radio 0:
      Status= Enabled
      AdjacentThreshold= 25
      WeakBypass= 33
      StrongBypass= 55
      ActivationThreshold= 10
      NewTrigger= 3
      Headroom= 3

  Radio 1:
      Status= Disabled
      AdjacentThreshold= 43
      WeakBypass= 35
      StrongBypass= 55
      ActivationThreshold= 10
      NewTrigger= 3
      Headroom= 3


ruckus(config-load-balancing)#