get bond

Use the following command to display the LACP status on a member AP:

ruckus> en
ruckus# ap-mode
You have all rights in this mode.
ruckus(ap-mode)# get bond
LACP/Bonding is DISABLED.
OK
ruckus(ap-mode)# get bond
LACP/Bonding is ENABLED.
<bond0>
        Mode:           8023AD
        LACP-rate:      fast
        MII-Mon:        100 (ms)
        Xmit-Hash:      layer2+3
        Slaves:         2
        Slave-0:        eth0, ACTIVE, DOWN TOO LONG, link-fail-count: 0
        Slave-1:        eth1, ACTIVE, UP, link-fail-count: 0
OK
Note: The get bond command is supported for 11ax and Wave 2 APs.
Note: To enable or disable LACP on Master AP, use the status-lacp [enable | disable ] command.