Creating a Split Tunnel Profile

When applied, the profile directs corporate traffic to the Data Plane tunnel or to Local Breakout (LBO) according to rule entries, allowing you to optimize bandwidth and latency for specific destinations.
Note: SoftGRE (or RUCKUS GRE, if available) must be enabled on the target WLAN before you can map it to a Split Tunnel Profile.
Complete the following steps to create and configure a Split Tunnel Profile.
  1. In the controller web UI, select Services > Tunnels & Ports > Split Tunnel.
  2. Select the zone for which you want to create the profile and click Create.
    The Create Split Tunnel Profile window is displayed.

    Creating a Split Tunnel Profile

  3. In Name, enter a profile name.
  4. (Optional) In Description, enter a brief description.
  5. In Default Forwarding Mode, select one of the following options:
    • Local Break Out: By default, all outgoing traffic from the AP is sent to the internet. Traffic to destinations in the Exception Address List is tunneled.
    • Tunnel: By default, all outgoing traffic from the AP is tunneled. Traffic to destinations in the Exception Address List is sent to the internet.
  6. In Exception Address List, complete the following fields to add exceptions to the default forwarding mode configured in step 5:
    1. In IP Address, enter a destination IPv4 address.
    2. In Subnet Mask, enter the destination subnet mask.
    3. Click Add to add the destination entry to the exception address list.
  7. Repeat step 6 to add additional destinations as needed.
  8. Click OK to save the profile.
    Attention: Do not configure the same IP address in both a Walled Garden and the Split Tunnel Profile. The Walled Garden entry takes precedence and overrides split‑tunnel behavior.
The Split Tunnel Profile is created for the selected Zone. When mapped to a WLAN, client traffic follows the selected Default Forwarding Mode, with exceptions applied to the destinations defined in the Exception Address List.
Note: You can also edit, clone, or delete the profile by selecting the options Configure, Clone, and Delete, respectively, from the Split Tunnel tab.