map vlan-range (VXLAN)

Maps a range of VLANs to a VXLAN Network Identifier (VNI) for a VXLAN overlay gateway.
Syntax
map vlan-range vlan-id to vlan-id vni-start vni-id
no map vlan-range vlan-id to vlan-id vni-start vni-id
Command Default

VLANs are not mapped to the VNI.

Parameters
vlan-id
Specifies the first VLAN you intend to map over the VXLAN. Valid values range from 1 through 4095.
to vlan-id
Specifies the range of VLANs you intend to map over the VXLAN.
vni-start vni-id
Starts the VNI that will be mapped to the VLAN. Valid values range from 1 through 16777215.
Modes

Overlay-gateway configuration mode

Usage Guidelines

The default VLAN cannot be mapped to a VNI. The maximum number of VLANs in a range is 256.

This command is supported for router images only. This command is supported for RUCKUS ICX 7550, ICX 7650, and ICX 7850 devices only.

For RUCKUS ICX 7650 and ICX 7850 devices, no more than 2 access ports per VLAN should be configured. 4080 VLAN VNI mappings are supported.

For RUCKUS ICX 7550 devies, no more than 2 access ports per VLAN should be configured. 3072 VLAN VNI mappings are supported when a maximum of 2 access ports are configured for each VXLAN mapped VLAN. 4080 VLAN VNI mappings are supported when a maximum of 1 access port is configured for each VXLAN mapped VLAN.

The no form of the command disables VLAN-to-VNI mapping for a range of VLANs.

Examples

The following example maps a range of VLANs (VLAN 200 through VLAN 300) to a VNI for a VXLAN overlay gateway. 

device# configure terminal
device(config)# overlay-gateway gate1
device(config-overlay-gw-gate1)# map vlan-range 200 to 300  vni-start 20000
History
Release version Command history
09.0.10d This command was introduced.
Parent topic: Commands M