Preparing the Controller’s Interface Settings to Use

The controller includes either one or two network interfaces (depending on the port group configuration that you will select (see Controller interfaces ) that need to be connected to the network for the appliance to work. If you select two-port configuration when you run the Setup Wizard later in this chapter, you will be required to assign each interface on the controller a separate set of network settings.

Hardware Requirement

The below table lists the details of hardware components.

Component Specific Information

Product Name

Label

Model

 
CPU Intel i7-3770 3.40 GHz, Socket: FCLGA1155
MB Caswell COB-7400-000  
Power Enhance ENP-7025D-47XGB  
RAM Innodisk - 8GB DDR3 1600 DIMM
HDD Western Digital - 1TB, 3.5” SATA HDD

Caution: If you select the two-port configuration, you must configure these two controller interfaces to be on different subnets. Failure to do so may result in loss of access to the web interface or failure of system functions and services.

The following network settings are required:

  • IP address

  • Netmask

  • Gateway

  • Primary DNS server

  • Secondary DNS server

Controller interfaces

Interface

Description

AP/ Management (Web)

Used for AP configuration, client traffic, and management traffic. The IP address that you assign to this interface will be the IP address through which you can access the controller’s web interface.

AP Tunnel

Used for tunnel traffic to and from the AP