Preparing the Administrative Computer

Note: This procedure assumes Windows 10 or 11 as the operating system. Procedures for other operating systems are similar.

Follow these steps to prepare the administrative computer that you will use to run the Setup Wizard.

  1. On the administrative computer, open the Network Connections (or Network and Dial-up Connections) control panel according to how your Start menu is set up:
    • Start > Settings > Network Connections
    • Start > Control Panel > Network and Sharing Center > Change Adapter Settings
  2. When the Network Connections windows appears, right click the icon for “Local Area Connection” and click Properties.
  3. When the Local Area Connection Properties dialog box appears, click Internet Protocol Version 4 (TCP/IPv4) from the scrolling list, then and click Properties. The TCP/IP Properties dialog box appears.

    Note: Write down all of the currently active settings so you can restore your computer to its current configuration later (when this process is complete).

    The Internet Protocol Version 4 (TCP/IP) properties dialog box

  4. Select Use the following IP address (if it is not already active) and make the following entries:
    • IP address: 192.168.2.13 (or any address on the 192.168.2.x network other than 192.168.2.2, which is in use by the controller)
    • Subnet mask: 255.255.255.0
    • Default gateway: 192.168.2.2
    • Preferred DNS server: 192.168.2.2
  5. Leave the Alternate DNS Server field empty.
  6. Click OK to save your changes and exit first the TCP/IP Properties dialog box, then the Local Area Connection Properties dialog box. Your changes are put into effect immediately.
You have completed preparing the administrative computer.