Enables SNMP traps for various events.
Syntax
snmp-server enable traps
event
no snmp-server enable traps
event
Command Default
Traps are enabled by default.
Parameters
- event
- The event for which the traps should be enabled. Enables the traps for one of the
following events:
- authentication
- Generates the trap when the authentication occurs.
- cold-start
- Generates the trap after a cold start.
- fan-failure
- Generates the trap when there is a fan failure and when the issue is resolved.
- fan-speed-change
- Generates the trap when there is a change in fan speed.
- ikev2
- Generates the trap for Internet Key Exchange Protocol, v2 (IKEv2) events.
- ipsec
- Generates the trap for Internet Protocol Security (IPsec) events.
- link-down
- Generates the trap when the link is down.
- link-oam
- Generates the trap for link OAM.
- link-up
- Generates the trap when the link is up.
- mac-authentication
- Generates the trap when a MAC address is added or deleted.
- mac-notification
- Generates the trap after a MAC authentication.
- metro-ring
- Generates the trap when there is a change in the Metro Ring configuration.
- module-inserted
- Generates the trap when a module is inserted.
- module-removed
- Generates the trap when a module is removed.
- new-root
-
Generates a control STP trap for newRoot events, as defined in RFC 1493.
- nlp-phy-40g
- Generates the trap during PHY calibration on the 40-Gbps and 4x10-Gbps stack ports.
- power-supply-failure
- Generates the trap when there is a power supply failure and when the issue is resolved.
- redundant-module
- Generates thea control enterprise trap snTrapMgmtModuleRedunStateChange for redundant
module events..
- syslog
- Generates syslogMsgNotification traps.
- temperature
- Generates the trap when there is a temperature change.
- topology-change
- Generates the control STP trap topologyChange defined in RFC 1493 for topology changes.
- udld
- Generates the control enterprise traps for Unidirectional Link Detection (UDLD) events.
- vsrp
-
Generates the control enterprise Virtual Switch Redundancy Protocol (VSRP) trap snTrapVsrpIfStateChange.
Modes
Global configuration mode
Usage Guidelines
The
no form of the command disables the traps.
The
ipsec and
ikev2 options are only supported on the
RUCKUS ICX 7450, with an FPGA-based add-on crypto card.
Examples
The following example enables SNMP traps on the device for MAC notification globally.
device(config)# snmp-server enable traps mac-notification
History
| Release version
|
Command history
|
| 08.0.10
|
The
mac-notification keyword was added.
|
| 08.0.50
|
The
ipsec and
ikev2 keywords were added.
|