`logmgr list`

Lists the existing logs on the connected units.

Syntax

logmgr list module sub-module severity unit-id

Command Default

Logs are not listed by default.

Parameters

module: Specifies a module or list of modules (separated by commas) for which logs are listed. Enter "all" to include all modules.
sub-module: Specifies a sub-module or list of sub-modules (separated by commas) for which logs are listed. You must enter "all" if multiple modules are specified. If only a single module is specified, then specify a single sub-module or list of sub-modules (separated by commas) belonging to the module.
severity: Specifies the severity level or list of severity levels (separated by commas) by which logs are listed. Enter "all" to include all severity levels.
unit-id: Specifies the unit or list of units (separated by commas) for which logs are listed. Enter "all" to list the logs from all units.

Modes

Privileged EXEC mode

Usage Guidelines

The command output lists the logs on units at the time of execution, not on fetched logs.

Examples

The following example displays the list of existing logs on a connected unit.

device# logmgr list infra stacking all 1
UNIT 1
       329643 infra/stacking/high
       339645 infra/stacking/low

History

Release version	Command history
08.0.95	This command was introduced.

logmgr list