all-client
all-client
{
ip-address
|
ipv6
ipv6-address
}
no all-client
{
ip-address
|
ipv6
ipv6-address
}
Remote management access is not restricted.
Global configuration mode
By default, an ICX device does not control remote management access based on the IP
address of the managing device. Using the
all-client command, you can alloq remote management access to a single IP address for all of
the following access methods:
You can specify only one IP address at a time. However, you can enter each command ten times to specify up to ten IP host addresses.
The
no form of the command removes the access restriction, if only one IP address has been
specified. If multiple IP host addresses have been allowed access, you must unconfigure
each one