register-probe-time

Configures the time the PIM router waits for a register-stop from a rendezvous point (RP) before it generates another NULL register to the PIM RP
Syntax
register-probe-time seconds
no register-probe-time seconds
Command Default

The wait time is 10 seconds.

Parameters
seconds
Specifies the time, in seconds, between queries. The range is 10 through 50 seconds. The default is 10 seconds.
Modes

PIM router configuration mode

Usage Guidelines

The no form of this command restores the wait time to 10 seconds.

The register-probe time configuration applies only to the first-hop PIM router.

Note: When a PIM first-hop router has successfully registered with a PIM RP, the PIM first-hop router will not default back to the data registration. All subsequent registers will be in the form of the NULL registration.
Examples

This example configures the register-probe time to 20 seconds. 

Device(config)#router pim
Device(config-pim-router)#register-probe-time 20
Parent topic: Commands O, P, Q, R, and Sa through Sh