rebind-time (DHCPv6)

Specifies the time interval after which a client transitions to the rebinding state after receiving an IPv6 address.
Syntax
rebind-time interval
no rebind-time interval
Command Default

The rebind time interval is 0 seconds by default.

Parameters
interval
Specifies the time interval in seconds. Valid values range from 0 through 65535. The default is 0.
Modes

DHCPv6 server configuration mode

Usage Guidelines

To use this command, you must upgrade to FastIron 08.0.90 using the Unified FastIron Image (UFI). Refer to the “Software Upgrade and Downgrade” chapter in the RUCKUS FastIron Software Upgrade Guide for more information.

The rebind time should always be greater than the renewal time. Refer to the renewal-time command for more information.

When configuring the DHCPv6 server using this command along with the preferred-lifetime (DHCPv6), renewal-time (DHCPv6), and valid-lifetime (DHCPv6) commands, enter the commands in the following order:

  1. preferred-lifetime (DHCPv6)
  2. valid-lifetime (DHCPv6)
  3. rebind-time (DHCPv6)
  4. renewal-time (DHCPv6)
Note: Failure to enter the commands in the order outlined previously when configuring the DHCPv6 server results in a CLI error.

The no form of the command restores the default.

Examples

The following example sets the rebind time interval for a DHCPv6 server to 450 seconds. 

device# configure terminal
device(config)# ipv6 dhcp6-server enable
device(config-dhcp6)# rebind-time 450
History
Release version Command history
08.0.90 This command was introduced.

Related commands:

preferred-lifetime (DHCPv6)
Parent topic: Commands O, P, Q, R, and Sa through Sh