range6 (DHCPv6)

Specifies a range of IPv6 prefixes for a subnet for a DHCPv6 server.
Syntax
range6 ipv6-address1 lower-range ipv6-address2 upper-range
range6 ipv6-prefix
Command Default

No range of IPv6 addresses or IPv6 prefixes is specified.

Parameters
ipv6-address1 lower-range ipv6-address2 upper-range
Assigns IPv6 addresses in the specified range.
ipv6-prefix
Assigns an IPv6 address in the specified prefix.
Modes

DHCPv6 subnet configuration mode

Usage Guidelines

To use this command, you must upgrade to FastIron 08.0.90 using the Unified FastIron Image (UFI). Refer to the “Software Upgrade and Downgrade” chapter in the RUCKUS FastIron Software Upgrade Guide for more information.

The no form of the command removes a configured range of IPv6 addresses or IPv6 prefixes.

Examples

The following example specifies a range of IPv6 addresses for a subnet configured for the DHCP6 server. 

device# configure terminal
device(config)# ipv6 dhcp6-server enable
device(config-dhcp6)# subnet6 3ffe:501:ffff:100::/64
device(config-dhcpv6-subnet)# range6 3ffe:501:ffff:100::10 3ffe:501:ffff:100::20
History
Release version Command history
08.0.90 This command was introduced.
Parent topic: Commands O, P, Q, R, and Sa through Sh