refresh-time (DHCPv6)

Sets the refresh time for a DHCPv6 Server.
Syntax
refresh-time interval
no refresh-time interval
Command Default

No refresh time interval is configured.

Parameters
interval
Specifies the time interval in seconds. Valid values range from 0 through 65535. The default is 0.
Modes

DHCPv6 server configuration mode

Usage Guidelines

To use this command, you must upgrade to FastIron 08.0.90 using the Unified FastIron Image (UFI). Refer to the “Software Upgrade and Downgrade” chapter in the RUCKUS FastIron Software Upgrade Guide for more information.

The no form of the command restores the default.

Examples

The following example sets the refresh time for a DHCPv6 server to 80 seconds. 

device# configure terminal
device(config)# ipv6 dhcp6-server enable
device(config-dhcp6)# refresh-time 80
History
Release version Command history
08.0.90 This command was introduced.
Parent topic: Commands O, P, Q, R, and Sa through Sh