originator-id

Configures MSDP to use the specified interface IP address as the IP address of the rendezvous point (RP) in a source-active (SA) message.
Syntax
originator-id type number
no originator-id type number
Command Default

MSDP uses the IP address of the originating RP in the RP address field of the SA message.

Parameters
type
Specifies the type of interface used by the RP. You can use Ethernet, loopback, and virtual routing interfaces (ve).
number
Specifies the interface number. For example, the Ethernet port number, loopback number, or virtual routing interface number.
Modes

MSDP router configuration mode

MSDP router VRF configuration mode

Usage Guidelines

The no form of this command restores the default

Examples

This example configures an interface IP address to be the IP address of the RP. 

Device(config)# interface loopback 2
Device(config-lbif-2)# ip address 2.2.1.99/32
Device(config)# router msdp
Device(config-msdp-router)# originator-id loopback 2
Device(config-msdp-router)# exit

This example configures an interface IP address to be the IP address of the RP on a VRF named blue. 

Device(config)# interface loopback 2
Device(config-lbif-2)# ip address 2.2.1.99/32
Device(config)# router msdp vrf blue
Device(config-msdp-router-vrf blue)# originator-id loopback 2
Device(config-msdp-router-vrf blue)# exit
Parent topic: Commands O, P, Q, R, and Sa through Sh