AP image signing failed

Note: APs earlier than release 3.4 cannot be aligned to join SmartZone release 3.6.x due to mismatch in image format. Alarm code 187 will be raised with AP MAC address.

Note: USI: Un Signed Image

ISI: Intermediate Signed Image

FSI: Fully Signed Image

Note: This alarm is supported on the SmartZone 300 controllers only. This alarm is not applicable for vSZ-H.

AP image signing failed alarm

Alarm

AP Image signing failed

Alarm Type

apSigningInformation

Alarm Code

187

Severity

Informational

Aggregation Policy

From the event code 187 an alarm is raised for every event. A single event triggers a single alarm.

Attribute

"apMac"=”xx:xx:xx:xx:xx:xx”

Displayed on the web interface

AP Image Signing: The AP[{apMac}] with firmware version [{fwVersion}] is USI. USI to FSI upgrade is not allowed due to difference in Image formats.

Description

This alarm is triggered when the upgrade fails due to AP image mismatch.

Recommended Actions

This issue of not able to upgrade from releases prior to or from 3.2.x to R3.6+ occurs as per the following category.

  • Category 1: AP firmware images for releases prior to 3.4.x is in the format USI (Un Signed Image)
  • Category 2: AP firmware images for releases 3.4.x and 3.5.x is in the format ISI (Intermediate Signed Image)
  • Category 3: AP firmware images for releases 3.6 and above is in the format FSI (Fully Signed Image)

When upgrading from releases prior to 3.4 to 3.6.x and above, the AP image in category1 (USI) should be first upgraded to category 2 (ISI) and only then upgraded to category 3 (FSA). For example, move the AP image first to 3.4 or 3.5 zone and then to 3.6.x zone. If you attempt to do a direct upgrade (from USI to FSI) alarm 187 is triggered.

If you are unable to upgrade the AP image using the controller web user interface, you can alternatively upgrade through TFTP or FTP using CLI mode as per the below steps.

  • Step 1: Configure FTP or TFTP server in the network with any image (even FSI for 3.6.x is allowed)
  • Step 2: Login to AP CLI and configure TFTP or FTP server IP address and image file name by using the command fw set and its related sub options.
  • Step 3Execute the command fw update
  • Step 4: On completion of step 3 you can now upgrade the API image to ISI > FSI using the controller web user interface.