Displaying the Error Disable Recovery State by Interface

The port status of errdisabled displays in the output of the show interface and the show interface brief commands. In this example, errdisable is enabled on interface ethernet 1 and errdisable is enabled because of a BPDU guard violation. 

device# show interfaces ethernet 1/1/1
GigabitEthernet1/1/1 is ERR-DISABLED (bpduguard),
 line protocol is down
	BPDU guard is Enabled, ROOT protect is Disabled
	Port down for 2 hours 45 minutes 10 seconds
	Hardware is GigabitEthernet, address is 0000.00a0.7100 (bia 0000.00a0.7100)
	Configured speed auto, actual unknown, configured duplex fdx, actual unknown
	Configured mdi mode AUTO, actual unknown
	Member of L2 VLAN ID 2, port is untagged, port state is DISABLED
	STP configured to ON, priority is level0, flow control enabled
	mirror disabled, monitor disabled
	Not member of any active trunks
	Not member of any configured trunks
	No port name
	IPG MII 96 bits-time, IPG GMII 96 bits-time
	IP MTU 1500 bytes
	300 second input rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
	300 second output rate: 0 bits/sec, 0 packets/sec, 0.00% utilization
	145 packets input, 23561 bytes, 0 no buffer
	Received 124 broadcasts, 21 multicasts, 0 unicasts
	1 input errors, 0 CRC, 0 frame, 0 ignored
	0 runts, 0 giants
	5067 packets output, 330420 bytes, 0 underruns
	Transmitted 90 broadcasts, 4977 multicasts, 0 unicasts
	0 output errors, 0 collisions
Parent topic: Error Disable Recovery