sFlow Collector Table

Currently, RFC 3176 allows only one sFlow destination to be configured. To configure two or more destinations, use the following table.

Name, OID, and syntax	Access	Description
snSflowCollectorTable 1.3.6.1.4.1.1991.1.1.3.19.2 Syntax: Sequence of SnSflowCollectorEntry	Not-accessible	Table of all but first sFlow collectors. The first collector can be configured using sFlowTable in RFC 3176. The RFC cannot be used to configure more than one sFlow collector. This table has been created to fill this gap.
snSflowCollectorEntry 1.3.6.1.4.1.1991.1.1.3.19.2.1 Syntax: SnSflowCollectorEntry	Not-accessible	A row in the sFlow collector table.
snSflowCollectorIndex 1.3.6.1.4.1.1991.1.1.3.19.2.1.1 Syntax: Integer32	Read-only	The index to the sFlow collector table.
snSflowCollectorIP 1.3.6.1.4.1.1991.1.1.3.19.2.1.2 Syntax: IpAddress	Read-write	The IP address of the sFlow collector.
snSflowCollectorUDPPort 1.3.6.1.4.1.1991.1.1.3.19.2.1.3 Syntax: Integer32	Read-write	The number of the UDP port used by the sFlow collector.
snSflowCollectorRowStatus 1.3.6.1.4.1.1991.1.1.3.19. 2.1.4 Syntax: Integer	Read-write	Controls the management of the table rows. The following values can be written: delete(3) - Deletes the row. create(4) - Creates a new row. modify(5) - Modifies an existing row. If the row exists, then a SET with a value of create(4) returns a "bad value" error. Deleted rows are removed from the table immediately. The following values can be returned on reads: noSuch(0) - No such row. other(1) - Some other case. valid(2) - Row exists and is valid.