Setting Module 2 to Uplink-100-Gbps Mode

Breakout is supported only on module 2 in all ICX 7550 models. Use the slot 2 uplink-100g command to set module 2 uplink-100-Gbps mode on the ICX 7550-24ZP, ICX 7550-48ZP, ICX 7550-24F, and ICX 7550-48F models. When slot 2 uplink-100g is configured, the supported modules in module 3 are 4x10-Gbps or 1x100-Gbps.

Note: The slot 2 uplink-100g command is not allowed if slot 3 has the ICX 7600-2x40-GQ 2-port 80-Gbps module present or configured.

  1. Enter global configuration mode.
    ICX7550-48F Router# configure terminal
  2. Enter the slot 2 uplink-100g command to configure module 2.
    ICX7550-48F Router(config)# slot 2 uplink-100g

Changes require reload to take effect. Please do write memory and then reload or power cycle!!!
Slot 2 will be operating in uplink mode with 100Gbps speed after reload

    ICX7550-48F Router(config)# exit
ICX7550-48F Router# write memory
ICX7550-48F Router# reload
  3. Enter the show running-config command to display the running configuration.
    ICX7550-48F Router# show running-config
Current configuration:
ver 08.0.95devT243
stack unit 1
module 1 icx7550-48f-port-management-module
module 2 icx7550-100g-2port-200g-module
stack mac 54ec.2f24.f8b6
slot 2 uplink-100g

The following example shows how to return to default mode.

ICX7550-48F Router(config)# no slot 2 uplink-100g
Changes require reload to take effect. Please do write memory and then reload or power cycle!!!
Slot 2 will be operating in default mode after reload.
Parent topic: Overview of Breakout Ports