Configuring a Dynamic Port Profile

Complete the following steps to configure a dynamic port profile.
Note: Port profiles are supported only on physical Ethernet ports.
Note: Do not include ports that are members of a LAG when specifying ports for a dynamic port profile.
  1. Enter global configuration mode.
    device# configure terminal
  2. Create a port profile and assign a profile name.
    device(config)# port-profile profile2
  3. Create an LLDP device entry, including the system name and system description.
    device(config-port-profile-profile2)# lldp-device system-name "RuckusAP" system-desc "Ruckus T310D Multimedia Hotzone Wireless AP/SW Version: 108.0.0.0.703"
  4. (Optional) Set access-list name for incoming packets.
    device(config-port-profile-profile2)# ingress-acl Test1
  5. To apply the configured port profile to the interface, disable and enable the interface after creating the dynamic port profiles. 
    device(config-port-profile-profile2)# exit
device(config)# interface ethernet 1/1/42
device(config-if-e1000-1/1/42)# disable
device(config-if-e1000-1/1/42)# enable
device(config-if-e1000-1/1/42)# exit
    Note: If you are connecting the powered devices (PDs) after the port profile creation, you do not need to disable and enable the interface. If the PD is connected to the switch before creating the port profile, disable and enable the interface as shown in the examples.
The following example configures a MAC-OUI entry.
device(config)# port-profile profile2
device(config-port-profile-profile2)# mac-oui
device(config-port-profile-profile2)# mac-oui F8:E7:1E 
device(config-port-profile-profile2)# exit
device(config)# interface ethernet 1/1/42
device(config-if-e1000-1/1/42)# disable
device(config-if-e1000-1/1/42)# enable
device(config-if-e1000-1/1/42)# exit
Parent topic: Port Profile