Configuring Client Isolation Mode

To isolate the client from the network when Cluster Communication Protocol (CCP) is not operational, enter the following commands.

  1. Enter the Global Configuration mode. 
    RUCKUS-1# configure terminal
  2. Configure a cluster name and ID. 
    RUCKUS-1(config)# cluster SW 4000
    If you do not specify a cluster name, the device will automatically generate the cluster name as CLUSTER-X.
  3. If the cluster is in the deploy state, changing the client isolation mode is not permitted. Use the no deploy command if necessary.
    RUCKUS-1(config-cluster-SW)# no deploy
  4. Change the isolation mode to strict mode. 
    RUCKUS-1(config-cluster-SW)# client-isolation strict
    Note: The CLI allows modification of the client isolation mode on MCT cluster devices. You must create the same isolation mode on both cluster devices.
Parent topic: Client Isolation Mode