ICX 7550 show stack Command Displays Local Unit Capability
The show stack command entered
on a ICX 7550 device displays information on the current configuration, the operationg
mode, and the speed of the device. The related output can be interpreted as follows:
- config - the current configuration mode
- oper - the current operating mode of the port (determined during bootup)
- Speed setting:
Note: The
show stack command
displays the capability of the local unit. The units in a stack may show different
oper modes. Note: The config and oper mode could be different
if the Module 2 profile configuration has changed but you have not yet entered the
The following write memory
and reload
commands.show stack output shows
that Module 2 of the local ICX 7550 device is configured for and operating in data
uplink mode and is 100-Gbps capable, depending on the installed cable and
optic.
ICX-7550# show stack
***** Warning! stack is not enabled. *****
T=4m39.4: alone: standalone, D: dynamic cfg, S: static
ID Type Role Mac Address Pri State Comment
1 S ICX7550-48ZP alone 28b3.7129.8856 0 local None:0
+---+
2/1| 1 |2/2
+---+
Current stack management MAC is 28b3.7129.8856
slot 2: config = oper = uplink-100g
The following output indicates that the ICX 7550 is operating in stacking mode at 100 Gbps.
slot 2: config = oper = stack-40g/100g All UP stack ports operate at 100G