Confirming Stack Software Versions

All units in a stack must be running the same software image. To confirm this, check the software version on all devices that you want to add to a stack. Upgrade any units that are running older versions of the software before you build the stack.

To check the software version for each stack member, perform the following steps.

  1. Use Telnet or SSH or connect to any of the console ports in the stack.
  2. Enter the show version command. Output similar to the following is displayed. 
    device# show version
  Copyright (c) 2017 Ruckus Wireless, Inc. All rights reserved.
    UNIT 1: compiled on Jul 31 2015 at 18:37:27 labeled as SWR08040b1
      (20197181 bytes) from Primary SWR08040b1.bin
        SW: Version 08.0.40b1T203
    UNIT 2: compiled on Jul 31 2015 at 18:37:27 labeled as SWR08040b1
      (20197181 bytes) from Primary SWR08040b1.bin
        SW: Version 08.0.40b1T203
    UNIT 3: compiled on Jul 31 2015 at 18:37:27 labeled as SWR08040b1
      (20197181 bytes) from Primary SWR08040b1.bin
        SW: Version 08.0.40b1T203
      Compressed Boot-Monitor Image size = 1835008, Version:10.1.01T205 (swz10101)
       Compiled on Fri Jun 27 22:01:35 2014
    Note: If any unit in the stack is running an incorrect version of the software, it will appear as non-operational. You must install the correct software version on that unit for it to operate properly in the stack.
Parent topic: Stack Software Images