clear chassis unit-id

Resets the LED warning light for a power supply after a temporary power fluctuation.
Syntax
clear chassis unit-id unit-number ps-device device-number }
Parameters
unit number
Specifies the Unit ID number. Valid values range from 1 through 12.
ps-device device-number
Specifies the power supply device number.
Modes

Global configuration mode

Usage Guidelines

When the Power Supply DC LED is blinking red, indicating that the power supply has detected an over-current condition, the warning light can be cleared using this command.

This command is supported for ICX 8200 and ICX 8100 devices only.

Examples

The following example clears PSU 1 over the current warning LED for an ICX 8200 standalone device.

ICX8200-48ZP2 Router# clear chassis unit-id 1 ps-device 1 led
ICX8200-48ZP2 Router#clear chassis unit-id 1 ps-device 2 led      (To clear PSU 2 over current warning led)

The following example clears PSU 2 over the current warning LED for an ICX 8200 standalone device.

ICX8200-48ZP2 Router# clear chassis unit-id 1 ps-device 2 led

The following example clears PSU 1 and PSU2 over the current warning LED of unit id 3 for a stack setup.

show stack

T=2m46.2: alone: standalone, D: dynamic cfg, S: static
ID   Type          Role    Mac Address    Pri State   Comment
1  S ICX8200-48PF  active  c0c5.2080.1bbc   0 local   Ready
2  S ICX8200-48P   standby c0c5.2080.23f6   0 remote  Ready
3  D ICX8200-48PF2 member  c0c5.2080.2a80   0 remote  Ready

   standby      active
     +---+        +---+        +---+
  2/3| 2 |2/1--2/3| 1 |2/1--2/3| 3 |2/1
     +---+        +---+        +---+
Standby u2 - Learn other units for 15 sec, protocols may not be ready in 55 s.
Current stack management MAC is c0c5.2080.1bbc

ICX8200-48PF Router# clear chassis unit-id 3 ps-device 1 led     
ICX8200-48PF Router# clear chassis unit-id 3 ps-device 2 led
History
Release version Command history
10.0.00 This command was introduced.
Parent topic: Commands C