The
RUCKUS Unleashed R670 is a tri-band
concurrent Wi-Fi 7 (IEEE 802.11be) indoor AP that supports six spatial data streams
(2x2:2
in 2.4GHz, 5GHz, and 6GHz [tri-band mode] or 2x2:2 in 2.4GHz and 4x4:4 in 5GHz [dual-band
mode]).
This AP provides Wi-Fi 7 features such as
Multi-Link Operation (MLO), Preamble Puncturing, 4K Quadrature Amplitude Modulation
(QAM), and 320 MHz Channels. The RUCKUS Unleashed AP includes a
USB port, a 5 Gbps Ethernet port (which supports IEEE Standards 802.3af, 802.3at,
and
802.3bt PoE), and a 1 GbE port (non-PoE).
This section describes the physical features of
the RUCKUS
Unleashed R670 AP.
Unleashed R670 Access Point
R670 AP Front Panel
The R670 AP features a single system LED on its
front panel that can display three colors (Red, Amber, and Green).
R670 AP Front Panel LED
| State Base Light |
Status |
Description |
| Power Negotiation Mode (Red) |
Off |
No power connected. |
| Slow Blinking Red (The light is on for 0.5 seconds and off for 1.5
seconds)
|
AP is on and in IEEE 802.3af low-power mode. |
| Solid Red |
AP is on and in full-power mode and boot-up is in
process. |
| Operation Preparation State (Amber) |
Blinking Amber (The light is on for 1 second and off for 1
second)
|
One of the following: System is in Configure.Me or Zero Touch
Mesh (ZTM) state. Management Gateway is lost.
|
| Solid Amber |
AP has successfully obtained an IP address, either
through DHCP or a static IP assignment. |
| Fast Blinking Amber (The light is on for 0.25 seconds and off for
0.75 seconds.
|
AP is being loaded with a configuration or firmware
update. |
| Slow Blinking Amber (The light is on for 0.5 seconds and off for 1.5
seconds)
|
Connection to the system controller is lost. |
| Service State (Green) |
Solid Green |
AP WLAN services and Controller management are operational. |
| AP WLAN has at least one client connected. |
| AP WLAN has at least one client connected and Mesh networking is
established. |
| Exception State |
Blinking between Red and Green |
AP is Factory Reset. |
| Blinking between Red and Amber |
AP is Factory Reset to Recovery Mode. |
| Blinking Red/Off/Green/Off/Amber/Off |
Controller is not reachable. |