Enabling L3 Roaming Criteria for DP
Using the layer 3 roaming feature, clients can roam across APs in the network (from
one data plane to another data plane). This is typically required when the number
of clients in the network increases and clients have to roam from a network that they
were connected to, to another WLAN network with similar access settings. This feature
enables seamless roaming and ensures session continuity between the client and the
network.
Note: L3 roaming is only supported on vSZ-H and vSZ-E.
You can configure the roaming criteria for a DP so that it uses one of these two options - UE subnet or WLAN VLAN to access another DP to connect to, within a network. Before this, you must ensure that the L3 roaming feature is enabled in the DP.
- From the main menu, go to .
5.1 update
- Select L3 Roaming.
- Click
Configure to edit the L3 roaming settings.
The Edit L3 Roaming page is displayed.
- From Activate, you can enable the feature for the DP by selecting Enable or Disable from the drop-down menu.
- From the
Roaming Criteria list, select one of the following options to define the data format to establish
connection between DPs:
UE Subnet or
SZ 5.1 updateWLAN VLAN.
- Click OK.
Note: If there are more than 40 DPs been approved, the controller limits you to use
L3 Roaming.
Note: A fresh
controller software installation or upgrade from a version that does not support
L3
roaming resets the L3 roaming configuration and it remains disabled. You must
enable
L3 roaming on a DP again.