Modifying and Displaying Layer 3 System Parameter Limits
Before manually changing IP system parameter values, you must view the existing values.
Changing the system parameters reconfigures the device memory. Whenever you reconfigure
the memory on a
RUCKUS device, you must save the change to the startup-config file using the
write memory command, and then reload the software to place the change into effect.
Note: The Layer 3 system parameter limits for RUCKUS ICX IPv6 models are automatically adjusted by the system and
cannot be manually modified.
To display the Layer 3 system parameter
defaults, maximum values, and current values, enter the show default value command at any
level of the CLI.
device# show default value sys log buffers:50 mac age time:300 sec telnet sessions:5 ip arp age:10 min bootp relay max hops:4 ip ttl:64 hops ip addr per intf:24 when multicast enabled : igmp group memb.:260 sec igmp query:125 sec hardware drop: enabled when ospf enabled : ospf dead:40 sec ospf hello:10 sec ospf retrans:5 sec ospf transit delay:1 sec when bgp enabled : bgp local pref.:100 bgp keep alive:60 sec bgp hold:180 sec bgp metric:10 bgp local as:1 bgp cluster id:0 bgp ext. distance:20 bgp int. distance:200 bgp local distance:200 System Parameters Default Maximum Current Configured ip-arp 4000 64000 4000 4000 ip-static-arp 512 6000 512 512 ip-cache 10000 32768 10000 10000 ip-filter-port 3071 3071 3071 3071 ip-filter-sys 3072 8192 3072 3072 l3-vlan 32 1024 32 32 ip-qos-session 1024 16000 1024 1024 mac 32768 32768 32768 32768 ip-route 12000 15168 12000 12000 ip-static-route 64 2048 64 64 some lines omitted for brevity.... dot1x-mka-policy-gro 8 8 8 8 openflow-flow-entrie 3072 12288 3072 3072 openflow-pvlan-entri 40 40 40 40 openflow-unprotected 40 40 40 40 openflow-nexthop-ent 1024 3072 1024 1024 max-ip-mac 128 256 128 128 max-dhcp-snoop-entri 1024 3072 1024 1024 max-static-inspect-a 512 1024 512 512