Configuring Client Isolation Mode

To isolate the client from the network when Cluster Communication Protocol (CCP) is not operational, enter the following commands.

  1. Enter the Global Configuration mode. 
    RUCKUS-1# configure terminal
  2. Configure a cluster name and ID. 
    RUCKUS-1(config)# cluster SW 4000
    If you do not specify a cluster name, the device will automatically generate the cluster name as CLUSTER-X.
  3. Change the isolation mode to strict mode. 
    RUCKUS-1(config-cluster-SX)# client-isolation strict
    Note: The CLI allows modification of the client isolation mode on MCT cluster devices even when the cluster is deployed. You must create the same isolation mode on both cluster devices.
Parent topic: Client Isolation Mode