lan rate-uplink

To set rate limiting on a port, use the following command:

lan NUMBER rate-uplink NUMBER

Note: The rate-uplink command is supported only for H550/H350 in Gateway mode.

Syntax Description

lan
Configure a specific port
NUMBER
Configure this port
rate-uplink
Set the uplink rate limiting
NUMBER
Enter the rate limiting to {NUMBER} Mbps, valid range is from 0 to 1000.

Defaults

None.

Example

ruckus(config-apgrp-port)# lan 1 rate-uplink 100
ruckus(config-apgrp-port)# show
PORTS:
    LAN ID:
          1:
            Rate Uplink= 100
ruckus(config-apgrp-port)#