If Your Network Uses SNMPv3

  1. Click the System Settings > SNMP tab.
  2. Under SNMP v3 Settings, configure the following settings:
    1. User Name: Enter a user name between 1 and 31 characters long.
    2. Auth Protocol Select MD5, SHA or NONE authentication method (default is MD5).
      • MD5 (Message-Digest algorithm 5) is a message hash function with 128- bit output.
      • SHA (Secure Hash Algorithm) is a message hash function with 160-bit output.
    3. Auth Password: Enter a passphrase between 8 and 32 characters long.
    4. Priv Protocol: Select DES, AES or NONE.
      • DES (Data Encryption Standard), data block cipher.
      • AES (Advanced Encryption Standard), data block cipher.
      • NONE: No Privacy passphrase is required.
    5. Priv Password: If either DES or AES is selected, then enter a Privileged Password between 8 and 32 characters long.
    6. Read: Select this check box to enable SNMP read access.
    7. Trap: Select this check box to send SNMP traps to the trap server on the network.
    Note: To add another SNMP v3 community string, click the icon, and then configure the community string and read and trap privileges.
  3. Click Save to save your changes.
  4. Under SNMP Trap, configure the following settings:
    1. SNMP Version: Select V3.
    2. Security Name: Enter the security name.
    3. Target Address: Enter the IP address of the SNMP trap receiver.
    4. Target Port: Enter the SNMP port number on the SNMP trap receiver.
  5. Click Save to save your changes.