The
show running-config command displays information about the current stack configuration as shown in the
following example. Some configuration information, such as sz registrar, is added
by default.
ICX7850-32Q Router# show running-config
Current configuration:
!
ver 09.0.00
!
stack unit 1
module 1 icx7850-32q-port-management-module
module 2 icx7800-100g-12port-1200g-module
module 3 icx7800-100g-8port-800g-module
stack-trunk ethernet 1/3/1 to 1/3/4
stack-trunk ethernet 1/3/5 to 1/3/8
stack unit 2
module 1 icx7850-48fs-port-management-module
module 2 icx7800-100g-8port-800g-module
stack-trunk ethernet 2/2/1 to 2/2/4
stack-trunk ethernet 2/2/5 to 2/2/8
stack enable
stack mac d4c1.9e18.3731
!
!
aaa authentication web-server default local
aaa authentication login default local
enable aaa console
!
no telnet server
username super password .....
!
!
hitless-failover enable
!
!
sz registrar
!
!
end
Field Descriptions for the
show running-config Command
Field
|
Description
|
ver
|
Software version the stack is running
|
stack unit #
|
The stack identification number for this unit
|
module #
|
Identifies the configuration for each module installed in the stack unit
|
priority
|
Indicates the priority assigned to the stack unit
|
stack-port
|
Lists stacking ports configured on the stack unit
|
stack-trunk
|
Indicates the trunk configuration
|
stack enable
|
Indicates whether the stack is enabled
|
stack mac
|
Specifies the mac address for the stack
|
aaa authentication web-server default local
|
Indicates the authentication method to access the device through web management is
to use local username and password
|
aaa authentication login default local
|
Indicates the authentication method to access the device through cli via telnet/ssh
is to use local username and password
|
enable aaa console
|
Indicates authentication, authorization, and accounting (AAA) is enabled on the console
|
(no) telnet server
|
Indicates whether telnet server is enabled or not on this device
|
hitless-failover enable/disabled
|
Indicates whether hitless failover is enabled
|
sz registrar
|
Present by default and indicates that the device can initiate auto-discovery of up
to two configured SmartZone management IP addresses by querying a pre-configured URL.
Refer to SmartZone administrator guides for more information.
|
sz active-list
ip address, ip address
|
Displays the list of IP addresses used by the ICX device to connect to SmartZone.
Refer to SmartZone administrator guides for more information.
|
interface management 1
|
Indicates FastIron management port
|
ip address
|
Indicates the IP address that identifies the stack
|