set internal-network

To set the internal network.
Syntax
set internal-network ipv4-network
Parameters
ipv4 network
Speicfy the internal IPv4 address.
Modes

Basic mode

Advanced mode

Usage Guidelines

If the RUCKUS Edge deployment environment and the RUCKUS Edge device use the same network, you can use the set internal-network command to change the internal services network, which helps to prevent conflicts. The command will automatically set the device internal network to subnet /16 network. It is important to make this change before enrolling the device with Ruckus One.

The following example shows sample output for the set internal-network command.

Examples
SmartEdge# set internal-network 10.128.0.0
Warning: Set internal network will erase all current settings and reboot the device.
The operation will set the device internal network to be 10.128.0.0/16.
Are you sure that you want to proceed with the setting and rebooting the device?
(yes/N)
After restarting the system, use the show internal-network command to verify if the changes have been applied. 
SmartEdge# show internal-network
Internal Network: 10.128.0.0/16
History
Release version Command history
1.0.0 This command was introduced.
Parent topic: Basic Mode Commands