network

Enters the network configuration mode, providing access to perform network-related configurations and diagnostic operations.
Syntax
network
Command Default

The network mode is not enabled.

Modes

Advanced mode

Usage Guidelines

Use this command to enter the Network mode from the Advanced mode. After entering the Network mode, you can configure network interfaces, manage link aggregation (LAG), run diagnostics (for example, ping, traceroute, and nslookup), capture network traffic, and view or modify advanced network settings like DHCP, DNS, and VXLAN configurations.

Examples

The following example shows how to enter the Network mode from the Advanced mode.

SmartEdge> enable
Password:
SmartEdge# network
Network # help
Avaliable Command:
  ?
  clear vxlan-gpe tunnel keepalive session statistics
  create lag
  delete lag
  exit
  help
  lag add
  lag remove
  nslookup
  packet-capture filter
  packet-capture save
  packet-capture start
  packet-capture status
  packet-capture stop
  ping
  set default gateway
  set dns server
  set interface ip address
  set interface state
  set log level
  show default gateway
  show dhcp client
  show dns server
  show hqos bw_profile
  show hqos interface
  show hqos queue
  show interface address
  show lacp
  show lag
  show log level
  show peer-tunnel
  show pin-info
  show pin-pan
  show route
  show sdlan config
  show sdlan counters
  show sdlan info
  show sdlan peer
  show sdlan summary
  show tunnel profile
  show version
  show vxlan config
  show vxlan dstats
  show vxlan pmtu table
  show vxlan tunnel
  show vxlan tunnel profile
  show vxlan-gpe config
  show vxlan-gpe dstats
  show vxlan-gpe pmtu table
  show vxlan-gpe tunnel
  show vxlan-gpe tunnel keepalive session
  start dhcp client
  stop dhcp client
  traceroute
For Detail Information: [command] help
  e.g. set interface help
History
Release version Command history
1.0.0 This command was introduced.
Parent topic: Basic Mode Commands