packet-capture save

Downloads the packet capture (.pcap) file using TFTP or FTP.
Syntax
packet capture save [sftp | ftp server_ip username password server_path
Parameters
tx
Captures transmitted packets.
rx
Captures received packets.
drop
Captures dropped packets
sftp
Specifies the Secure File Transfer Protocol (SFTP) to use for transferring the file.
ftp
Specifies the File Transfer Protocol (FTP) to use for transferring the file.
server_ip
Specifies the IPv4 address of the SCP server or the TFTP server.
username
Specifies the username to authenticate with the remote server.
password
Specifies the password associated with the username.
server_path
Specifies the path on the remote server where to save the .pacp file.
Modes

Network configuration mode

Usage Guidelines

Examples

The following example downloads the .pcap file from RUCKUS Edge using SFTP. 

Network# packet-capture save sftp 10.206.82.63 username password /upload
Captured file found, start sftp upload...
packet-capture.pcap       | 1653 kB | 1653.2 kB/s | ETA: 00:00:00 | 100%
History
Release version Command history
1.0.0 This command was introduced.
Parent topic: Basic Mode Commands