`packet-capture start`

Starts capturing packet data into a buffer.

Syntax

packet-capture start [ tx ] [rx ] [drop ] [max num_of_captured_packet | 1-50000] [interface interface]

Parameters

max num_of_captured_packet | 1-50000: Specifies the maximum number of packets to capture. The valid range is 1 through 50000 packets.
interface interface: Specifies the username to authenticate with the remote server.

Modes

Network configuration mode

Usage Guidelines

This command is supported only on RUCKUS Edge.

Examples

The following example stops capturing packet data into a buffer.

Network# packet-capture start 
Your packet capture is running in filter mode
Packet capture start...

History

Release version	Command history
1.0.0	This command was introduced.

packet-capture start