Enabling OSPFv3 in a non-default VRF

When OSPFv3 is enabled in a non-default VRF instance, the device enters OSPFv3 router VRF configuration mode. Several commands can then be accessed that allow the configuration of OSPFv3.

Note: ICX 7150 devices do not support VRFs.

Enter the configure terminal command to access global configuration mode.
```
device# configure terminal
```

Enter the vrf command and specify a name to enter Virtual Routing and Forwarding (VRF) configuration mode and create a non-default VRF instance.
```
device(config)# vrf green
```

Enter the rd command, assigning an administrative number and arbitrary number the route, to distinguish a route for VRF green.
```
device(config-vrf-green)# rd 100:200
```

Enter the ip router-id command to specify the router ID.
```
device(config-vrf-green)# ip router-id 10.11.12.14
```

Enter the address-family ipv6 command to enter IPv6 address-family configuration mode.
```
device(config-vrf-green)# address-family ipv6
```

Enter the exit command until you return to global configuration mode.
```
device(config-vrf-green-ipv6)# exit
```

Enter the ipv6 router ospf command and specify a VRF name to enter OSPFv3 router VRF configuration mode and enable OSPFv3 on a non-default VRF.
```
device(config)# ipv6 router ospf vrf green
```

The following example enables OSPFv3 in a non-default VRF.

device# configure terminal
device(config)# vrf green
device(config-vrf-green)# rd 100:200
device(config-vrf-green)# ip router-id 10.11.12.14
device(config-vrf-green)# address-family ipv6
device(config-vrf-green-ipv6)# 
device(config-vrf-green-ipv6)# exit
device(config)# ipv6 router ospf vrf green
device(config-ospf6-router-vrf-green)#

RUCKUS FastIron Layer 3 Routing Configuration Guide, 09.0.10 53-1005722-17

Enabling OSPFv3 in a non-default VRF