Configuring NTP over Management VRF on an NTP Server
To implement NTP over Management VRF, a Network Time Protocol (NTP) server device
must be configured to communicate with NTP client devices.
After configuring the NTP server, configure the NTP client devices.
- Enter global configuration mode.
- Configure a port-based VLAN and enter VLAN configuration mode.
- Add an untagged port to the VLAN.
- Attach a router interface to VE interface 20.
- Exit to global configuration mode.
- Configure the VRF named management as a global management VRF.
- Enter virtual interface mode for interface ve 20.
- Configure the VRF named management as a forwarding VRF.
- Configure an IP address on the interface.
- Exit to global configuration mode.
- Enable the Network Time Protocol (NTP) client and server mode.
- Configure the device as an NTP master clock to which peers synchronize themselves when an external NTP source is not available.
The following example configures NTP over Management VRF on an NTP server, including the initial VRF configuration.
configure terminal vrf MGMT rd 3:3 address-family ipv4 ip route 0.0.0.0/0 10.10.10.1 exit-address-family exit-vrf vlan 10 by port untagged ethernet 2/1/47 router-interface ve 20 exit management-vrf MGMT interface ve 20 vrf forwarding MGMT ip address 10.10.10.1 255.255.255.0 exit ntp master
