Unicast Reverse Path Forwarding

In this section:

1. Unicast Reverse Path Forwarding
   The unicast Reverse Path Forwarding check is used to avoid source IP-based spoofing and a malformed source IP address.
2. Configuration Considerations for uRPF
   The following configuration considerations apply to unicast Reverse Path Forwarding (uRPF) on supported RUCKUS devices.
3. Unicast Reverse Path Forwarding Feasibility
   The following table provides support information about uRPF.
4. System-Max Changes and uRPF
   The following tables describe the system-max values with and without uRPF configured on the device. Note that the values with uRPF configuration after reload are reduced by half.
5. Enabling Unicast Reverse Path Forwarding
   Unicast Reverse Path Forwarding can be enabled in different modes.
6. Configuring unicast Reverse Path Forwarding modes
   You can configure the various uRPF modes on a Layer 3 VE or physical interface.
7. Enabling uRPF check on PE ports
   To enable uRPF check, PE ports must be part of a VE interface. You cannot configure uRPF on physical PE ports.