Configuring virtual links

If an Area Border Router (ABR) does not have a physical link to a backbone area, a virtual link can be configured between that ABR and another device within the same area that has a physical link to a backbone area.

A virtual link is configured, and a virtual link endpoint on two devices, ABR1 and ABR2, is defined.

On ABR1, enter the configure terminal command to access global configuration mode.
```
device# configure terminal
```

Enter the ip router-id command to specify the router ID.
```
device(config) ip router-id 10.1.1.1
```

Enter the ipv6 router ospf command to enter OSPFv3 router configuration mode and enable OSPFv3 on the device.
```
device(config)# ipv6 router ospf
```

Enter the area command to assign an OSPFv3 area ID.
```
device(config-ospf6-router)# area 0
```

Enter the area command to assign an OSPFv3 area ID.
```
device(config-ospf6-router)# area 1
```

Enter the area virtual-link command and the ID of the OSPFv3 device at the remote end of the virtual link to configure the virtual link endpoint.
```
device(config-ospf6-router)# area 1 virtual-link 10.2.2.2
```

On ABR2, enter the configure terminal command to access global configuration mode.
```
device# configure terminal
```

Enter the ip router-id command to specify the router ID.
```
device(config) ip router-id 10.2.2.2
```

Enter the ipv6 router ospf command to enter OSPFv3 router configuration mode and enable OSPFv3 on the device.
```
device(config)# ipv6 router ospf
```

Enter the area command to assign an OSPFv3 area ID.
```
device(config-ospf6-router)# area 1
```

Enter the area command to assign an OSPFv3 area ID.
```
device(config-ospf6-router)# area 2
```

Enter the area virtual-link command and the ID of the OSPFv3 device at the remote end of the virtual link to configure the virtual link endpoint.
```
device(config-ospf6-router)# area 1 virtual-link 10.1.1.1
```

The following example configures a virtual link between two devices.

ABR1:
device1# configure terminal
device1(config)# ip router-id 10.1.1.1
device1(config)# ipv6 router ospf
device1(config-ospf6-router)# area 0
device1(config-ospf6-router)# area 1
device1(config-ospf6-router)# area 1 virtual-link 10.2.2.2

ABR2:
device2# configure terminal
device2(config)# ip router-id 10.2.2.2
device2(config)# ipv6 router ospf
device2(config-ospf6-router)# area 1
device2(config-ospf6-router)# area 2
device2(config-ospf6-router)# area 1 virtual-link 10.1.1.1

RUCKUS FastIron Layer 3 Routing Configuration Guide, 08.0.95 53-1005658-16

Configuring virtual links