Disabling or Re-enabling the Auto Image Copy Process for a Campus Fabric (SPX) Configuration

The auto image copy process is enabled by default but may be disabled.
You can use the image-auto-copy disable command to disable automatic image updates if you want to run different software versions on different units of a stack. This can be useful, for example, if you want to try out a RUCKUS patch image on just one unit.
  1. Check whether the auto image copy process is enabled by using the show stack detail command at the Privileged EXEC level on the stack active controller.
    The auto image copy process is disabled in the following show stack detail command output for an ICX 7750 traditional stack. 
    ICX7750-48C Router(config)# show stack detail
T=26m23.4: alone: standalone, D: dynamic cfg, S: static
ID   Type          Role    Mac Address    Pri State   Comment                   
1  S ICX7750-48XGF member  0000.0000.0000   0 reserve 
2  S ICX7750-26QXG standby 748e.f8f9.6700 255 remote  Ready
3  S ICX7750-48XGC active  cc4e.2438.6a80 255 local   Ready

    standby      active                                                        
     +---+        +---+                                                        
  2/1| 2 |2/4--2/1| 3 |2/4                                                     
     +---+        +---+                                                       
Standby u2 - No hitless failover. Reason: hitless-failover not configured
Current stack management MAC is cc4e.2438.6a80

Image-Auto-Copy is Disabled.

      Stack Port Status                        Neighbors                              
Unit# Stack-port1         Stack-port2          Stack-port1         Stack-port2        
2     dn (2/2/1)          up (2/2/4)           none                U3 (3/2/1)         
3     up (3/2/1)          dn (3/2/4)           U2 (2/2/4)          none               

Unit# System uptime
2     23 minute(s) 53 second(s) 
3     26 minute(s) 23 second(s)
  2. To re-enable auto image copy, enter the no image-auto-copy disable command in global configuration mode on the active controller as shown in the following example. 
    ICX7750-48C Router(config)# no image-auto-copy disable
Image mismatch Auto Copy enabled

SYSLOG: <14> Jan 11 02:51:04 System: Image mismatch Auto Copy Enabled
Parent topic: Campus Fabric (SPX) Image Upgrade