nat

Creates or sets the NAT server configuration settings.
Syntax
nat nat
no set [ filter ]
nat name

After the nat command is entered the following configuration syntax is available:

[ nat-log-syslog { level value } | set filter{ private-ip ip-address | private-portport-number | public-ipip-address |public-portport-number | ue-mac mac-address} | show ]

After the nat nat command is entered the following configuration syntax is available to set a pool of NAT servers:

name
Note: The show command is documented as separate command in the Show Command chapter. Refer to
Command Default

NAT server configurations is enabled on entering the nat command.

Parameters
nat-log-syslog value
Specifies the Syslog level in the range 1 to 7.
set filter
Sets the filter for ?
Modes

Global configuration mode

Usage Guidelines

This command is supported on the SmartZone Data Plane controllers only.

  • set filter private-ip ip-address sets the xxx.
    Need content
  • set filter private-portport-number sets the xxx.
    Need content
  • set filter public-ipip-address sets the xxx
    need content.
  • set filter public-portport-number sets the xxx.
    Need content
  • setfilter ue-mac mac-address sets the xxx.
    need content.

Examples

The following example sets the filter for NAT server. 

device# config
device(config)#  nat 
device((config-nat)#  set filter
device(config-nat)# set filter private-port 90
Remember type "end" and type "show ue-nat-session" in first layer 
<cr>
Parent topic: Commands J through N