ip data-nat

Sets up external NAT IP address of the data interface.
Syntax
ip data-nat{address | port }
no ip data-nat
Command Default

No external NAT IP is setup.

Parameters
address
IP address to set the external NAT server.
port
NAT server port number.
Modes

Global configuration mode

Usage Guidelines

This command is supported only on the SmartZone Data Plane controller.

Examples

The following example displays ip data-nat configuration.

device(config)# ip data-nat
 data-nat                            Set external NAT IP address of data interface
device(config)# ip data-nat 172.172.18.9 80
The command was executed successfully. To save the changes, type 'end'.
Examples

The below example displays no ip data-nat.

beta-tmp-BDC(config)# no
 ip-data-nat                         Remove external NAT of data interface
beta-tmp-BDC(config)# no ip-data-nat
 ip-data-nat                         Remove external NAT of data interface
beta-tmp-BDC(config)# no ip-data-nat 172.172.18.9 80
The command was executed successfully. To save the changes, type 'end'.
Parent topic: Commands G through I