controller

Enters Controller configuration mode to configure the virtual data plane settings.
Syntax
controller

After the controller command is entered to enable the Controller configuration mode, the following configuration syntax is available:

[history|ipip-address|logout|set_cert_chain|verify_cert_chain]
no{verify_cert_chain}
Command Default

The virtual data plane settings are not altered.

Parameters
history
Displays the list of previously run commands.
ipip-address
Specifies an IP address.
logout
Logs the user out.
set_cert_chain
Sets the vSZ certificate chain.
verify_cert_chain
Verifies the vSZ certificate chain by the controller.
Modes

Global configuration mode

Usage Guidelines

This command is supported on the SmartZone Data Plane controllers only.

Examples

The following example enters Controller configuration mode and sets an IP address. 

device# controller
 device(config-controller)#
 device(config-controller)# ip 10.1.1.1
The command was executed successfully. To save the changes, type 'end'.
device(config-controller)#
Parent topic: Commands A through C