VLANs

In this section:

  1. VLAN Overview
  2. Default VLAN
  3. Displaying VLAN Information
    After you configure the VLANs, you can verify the configuration using the various show commands.
  4. Layer 2 Port-Based VLANs
  5. Moving Untagged Port Membership from One Non-Default VLAN to Another
  6. Removing VLANs from Physical Ports
    You can remove VLANs from an Ethernet port, and the port will be added back to the default VLAN as an untagged member port.
  7. Assigning a Different VLAN ID to Default and Reserved VLANs
    You can assign a different VLAN ID to the default VLAN or to a reserved VLAN. When you enable port-based VLANs, all ports in the system are added to the default VLAN. By default, the default VLAN ID is "VLAN 1".
  8. Viewing Reassigned VLAN IDs for Reserved VLANs
  9. Add and Remove All Tagged VLANs
    A new wrapper is introduced to add and remove selective VLAN at the interface level.
  10. Multi-Range VLANs
  11. IEEE 802.1Q Tagging
  12. Spanning Tree Protocol
  13. Super-Aggregated VLANs
  14. LAG Interface and VLAN Membership
  15. Multiple VLAN Membership Rules
  16. Virtual Routing Interface Groups
  17. VLAN-Based Static MAC Entries Configuration
  18. VLAN Groups
  19. Topology Groups
  20. Aggregated VLANs (Tag Profiles)
  21. Simultaneous Support for Tagged and Untagged VLANs
  22. VLAN Mapping
    VLAN Mapping provides a mechanism for Service Providers to translate CVLANs to SVLANs when a packet enters its network and vice-versa, when it leaves the network.
  23. Private VLAN Configuration